jewelzuv printing

How-to

Press Instructions

General guidance for applying Jewelz UV Printing DTF transfers. Exact time, temperature, and pressure values are pending confirmation.

This page's full content is being finalized and will be published once approved. The information below is general guidance only. For specifics, please contact us.

  1. 1

    Pre-press the garment

    Press the garment for a few seconds to remove moisture and wrinkles before applying the transfer.

  2. 2

    Position the transfer

    Place the DTF transfer face-up on the garment. Cover with a protective sheet if recommended.

  3. 3

    Press

    Apply heat and pressure per the confirmed settings for your material. Exact time, temperature, and pressure are pending approval.

  4. 4

    Peel

    Allow to cool, then peel the film. A hot or cold peel depends on the transfer type — follow the confirmed guidance.

  5. 5

    Final press

    Apply a short final press with a protective sheet to set the transfer and improve durability.

UV DTF transfers apply to hard surfaces without a heat press — follow the surface preparation and application steps included with your order.